Products
History
Assembling
Recommends
for smoking
Contact
 
 
  Preparing your water pipe to smoke
  Preparing your water pipe to smoke :  
 

Screw your trunk pipe until it touches the plastic ring in the trunk.

Fill the glass base of the water pipe with Cold Water. You can add 8 - 10 pcs. of ice into the water. ( See article 4 below : for the water level. )

Screw your trunk to glass base until the base contacts the ring in the trunk.

Be sure that the trunk tube should be immersed into the water about 2 - 4 cm . If the water level is not proper , arrange the level accordingly , because it is very important.

Attach the hose to the trunk and make sure that the joint is airtight.

Test that your mounting is airtight by closing the trunk-end using your thumb. Try to suck your hose . There should NOT come any air through the hose. If any bubbles are formed in the water , that means there is air escape. ( your mounting is not perfect. ) To solve the air escaping problem , check :

  • O-ring of trunk pipe ,

  • Connecting point of trunk to Glass,

  • Connecting points of Hose,

  • Smoke release valve,

if necessary you should screw the parts a bit more without forcing.

By crumbling into the small pieces , put some tobacco to the tobacco bowl. NEVER PRESS the tobacco while placing in the bowl. The level of the tobacco should not exceed over the border of the bowl.

Cover the tobacco bowl with aluminum foil as tight as possible ( as shown in the below Picture ). If thick aluminum foil is not available you can use double or triple layer.
 

The Aluminum Foil should be pierced as shown in the Picture. You can use your tong's string or a toothpick or something sharp.
 
 
Place tobacco bowl on the top of the trunk with the bowl seal , be sure that the joint is airtight.
Now , You can light your charcoals of your water pipe. When your charcoal is burned , turn off your oven and let the burned charcoals wait for 1-2 minutes until the surface of the charcoals gets white.
Locate the Charcoals on the tobacco bowl as shown in the Picture. You can smoke your waterpipe with 2 pieces of charcoals. When the charcoals becomes smaller , you can continue smoking with the newly burned ( big size ) charcoals . The charcoals should be turned up and down and the locations of the charcoals on the bowl should be changed from time to time.